Maintenance and cleaning of the hood will not only improve the vehicle's appearance, but also extend the lifespan of the vehicle. Here are the detailed maintenance and cleaning steps:
I. Cleaning Steps
Preparation tools and materials:
Car wash or neutral detergent
Soft brush or sponge
Microfiber towel or clean cloth
Buckets
hose or pressure washer (optional)
Plastic or rubber protectant (if needed)
Rinse cap:
Use hose or pressure washer to flush hood surface under low pressure to remove loose dust and dirt.
Avoid spraying water directly into crevices or edges to prevent water from entering the engine compartment.
Use detergent:
Add a good amount of car wash liquid or neutral detergent to a bucket of water and stir well.
Soak a soft brush or sponge in the cleaning solution and apply evenly to the surface of the flue.
Gently Scrub:
Gently scrub the circle of the hood, paying particular attention to stubborn stains.
Avoid hard brushes or coarse cloth to avoid scratching paint.
Rinse again.
Wash the soot thoroughly with clean water to ensure that any residue from the cleaner is removed.
fuck. Use a microfibre towel or clean cloth to gently dry the hood surface to prevent water stains a microfiber towel or clean cloth.
II. Repair steps
Regular Waxing
Choose the appropriate wax: Choose solid wax, liquid wax or spray wax based on the paint type of the car.
Waxing: Apply wax evenly to the hood with a a dedicated waxing sponge or soft cloth.
Brighten up: When the wax is slightly dry, polish the paint surface in a circular fashion with a clean microfiber towel.
Frequency: Waxing is recommended every 3-4 months, depending on the environment and wax type.
Use a sealant (optional)
A sealant provide morelasting protection against UV rays, acid rain and pollutants.
The method is similar to hair removal, but the effect lasts longer, usually 6 to12 months.
Treat Scratches and defects
Minor scratches: Field treatment using scratch repair pen or polishing compound.
Deeper scratches: It is recommended to visit a specialist repair shop to avoid further damage caused by self-treatment.
Protective plastics and rubber parts: Special plastics and rubber protectors are applied to seal the edges of the hood and other rubber parts.
This prevents parts from aging and cracking and maintain them flexible.
Avoid high temperatures: Do not clean or maintain the soot machine in direct sunlight or at high temperatures to avoid cleaning agents drying quickly and leaving marks.
It's best to do it in a cool place, or in the early morning or evening when the temperature is cooler.
III. Preventive measures
Avoid strong acids and alkali cleaners: these chemicals can corrode paint and cause irreversible damage.
Be careful with water cannons: High water pressure can damage paint or cause moisture to seep into engine compartment.
Check the hood lock and hinges regularly: make sure they work properly and lubricate as needed.
NOTE: When cleaning or maintaining the hood, make sure the vehicle is in a stable condition to avoid accidents.

