This rear trunk spoiler is specially designed for the Mazda RX7 FD3S (1992–2002) in classic JDM style, combining aggressive aerodynamic styling with high-performance construction and lighting function.
This spoiler wing is lightweight, high-strength, and durable, effectively improving rear downforce and high-speed stability while enhancing the sporty racing look of your Mazda RX7. It features an integrated high-brightness LED tail lamp with rear lamp cover, increasing driving safety and visibility at night with a unique dynamic appearance.
Precision CNC-molded to ensure perfect fitment and consistent OEM mounting points, allowing direct bolt‑on installation without cutting or drilling. Finished with high-gloss UV-protective clear coat to prevent yellowing, fading and scratches, preserving the carbon fiber texture for long-term use.
Special designed for JDM enthusiasts, this spoiler restores the legendary RE style, upgrades the rear appearance, and adds exclusive racing character to your Mazda RX7 FD3S.
Installation Method
This RE style carbon fiber spoiler adopts direct bolt-on installation. It is developed for Mazda RX7 FD3S trunk original mounting positions, no large-scale cutting or body modification required.
Pre-fit alignment first Open the trunk lid, remove original spoiler if equipped. Place the new spoiler on the trunk for trial fitting, adjust centering and flatness, mark mounting positions to ensure no interference with taillight housing and trunk opening/closing.
Surface cleaning & waterproof treatment Wipe mounting contact area thoroughly with isopropyl alcohol to remove wax, dust and grease. Install rubber gaskets between spoiler base and car paint to prevent paint abrasion and water leakage.
Bolt fastening from inner trunk Align spoiler bottom holes with trunk pre-reserved holes, pass matched bolts through holes, install washers & lock nuts on inner side of trunk panel, tighten evenly step by step. Do not over-tighten to avoid cracking carbon fiber material.
LED wiring connection Route built-in LED lamp wiring through reserved gap into trunk interior, connect wiring harness to vehicle taillight circuit according to positive/negative polarity. Test LED running light and brake light functions to confirm normal lighting effect.
Final inspection & finishing Recheck spoiler level, tightness of all fasteners and wire fixation. Apply sealant around bolt holes optionally for better waterproof performance, then reinstall trunk interior trim panels to finish installation.
